Hi, after installing my MNBDM in my SMA OG E-panel I'd like to suggest that perhaps you could show the location in the E-panel you usually install this as I never found a spot where all 4 screws/standoffs lined up with pre-drilled holes and ended up drilling my own and probably not locating it in the most advantageous position in the E-panel. Some mention that the +, and - marking on the board for the connections to the remote trip breaker doesn't mean anything to the MNEDC breaker and that either of the unmarked yellow wires can go in either position - if this is not universal, then perhaps this could be mentioned on the remote trip breaker information as it doesn't even show the yellow wires, much less mention how they should be connected. Just my thoughts. Love your products.