Author Topic: Classic software information  (Read 105 times)

asdex

  • Full Member
  • ***
  • Posts: 145
Classic software information
« on: August 12, 2017, 03:03:40 AM »
Hi, not sure if this is the right section for this but could someone please explain the various values in the screenshot? Mainly the kWh and watts and which is which. eg which one is usage?
Thanks,

6 x JA Solar 320w solar panels, 2 x Solarex MSX-83, 3 x Helios H750 panels,
4 x 6v Crown CR430 batteries (24v), Classic and WBJr, FX2024 inverter and Mate, Trimetric monitor, Soma 1000 wind generator (to install), Lorentz P150-60 solar pump. Air X 400w wind generator.

dapsyra

  • Newby
  • *
  • Posts: 7
Re: Classic software information
« Reply #1 on: August 12, 2017, 07:44:20 AM »
The KWh is the total energy harvest for that day while the W is the peak instantaneous power produced by the solar panels.  Both values indicate production not usage.
PV-OUTPUT: http://pvoutput.org/list.jsp?userid=46221
Midnite Classic 150/WBJr., 15 Roysolar 300Wp, 48V/420AH AGM, Mercury MC5048E 5KVA Inverter

ClassicCrazy

  • Hero Member
  • *****
  • Posts: 1369
Re: Classic software information
« Reply #2 on: August 12, 2017, 10:21:01 AM »
If you have a Whizbang hooked up there is a  screen that shows SOC and the amount of net amp hours . There is also one that shows actual power being used which you can toggle between amps and watts.

Larry
system one
Classic 150 , 20 Kyocera 135watt , 12s Soneil 2v 540amp lead crystal for 24v pack , Outback 3524 inverter
system two
Classic 150 ,5s 135 watt Kyocero , 16s Calb 100AH LiFePO4 , Outback VFX 3648 inverter
system three
Midnite KID MPPT 24 DC in to  12 volt AGM batterie