Author Topic: Low voltage disconnect  (Read 371 times)


  • Newby
  • *
  • Posts: 9
Low voltage disconnect
« on: September 01, 2017, 01:52:43 PM »
How do you determine what the low voltage disconnect setting is on a Classic 200?


  • Hero Member
  • *****
  • Posts: 1694
Re: Low voltage disconnect
« Reply #1 on: September 01, 2017, 02:09:50 PM »
Do you mean to disconnect a load  ?

To disconnect a load you would need to connect the load via relay or some other switching device to one of the Aux contacts and if you look in the manual there are a lot of options for how to control loads with voltage , soc, etc.  So you need to set up the Aux to do exactly what you want.

system one
Classic 150 , 5s4p  Kyocera 135watt , 12s Soneil 2v 540amp lead crystal for 24v pack , Outback 3524 inverter
system two
Classic 150 ,5s 135 watt Kyocero , 16s Calb 100AH LiFePO4 , Outback VFX 3648 inverter
system three
Midnite KID MPPT 24 DC in to  12 volt AGM batterie