Load Function - No Voltage

Started by TexasSolar, September 10, 2017, 12:42:55 PM

Previous topic - Next topic

TexasSolar

Hi, new to the forum and could use some help.  My KID has been running great for about 3 months, but I decided to add a fan to the system to keep it cool during Bulk MPPT Charging.  When I activated the LOAD FUNCTION for Daylight Use...the Clipper light comes on.  When I test the output voltage, it's about .1V....less than .1AMPs is displayed on the KID readout.  Am I doing something wrong?  Is there a mode I did not activate?  Appreciate any help.

Thank You.

Highflyer

TS,
Try "manual on" if that does not work...

Do you have the load fuse installed (it is the horizontal one on the left with the long fuse cover)?  It needs to be on the left two leads.  Do you have the load (fan) wired up to the load leads?  Also, try several modes. I have used "float off," "float off," and "PWM divert" on all of my Kids and they have all done well for me.  Also, A picture would help us help you.
Brian

The one thing is the one thing