How do I navigate to put in the total Amp Hours of my Batteries on a 150 Classic

Started by Rafe, October 26, 2017, 12:26:49 AM

Previous topic - Next topic

Rafe

How do I navigate to put in the total Amp Hours of my Batteries on a 150 Classic. I did it when it was new along with the 2X360 AH LiFePo batteries but for the life of me can not find it again in any menu. & am experiencing reading anomolies eg; The 150 typically says 90% & the BMS on the LiFePo Batteries says 70% . These percentages are examples only. I just need the sequence in the menu to find " Battery capacity"

Vic

Hi Rafe,   Welcome to the Forum.

You probably have this doc on installing and setup of the WbJr:

http://www.midnitesolar.com/pdfs/Whizbang_manual.pdf

Page 3 begins the Setup process.

Basically,  press the left small Status screen button THREE times ...   this gets you to the Wb Status screen.   Press the upper Left soft button (More),   which should allow you to set the AH Capacity value for your batteries.

Others here can tell you their settings for their LiFePo batteries.

Vic
Off Grid - Sys 1: 2ea SW+ 5548, Surrette 4KS25 1280 AH, 5.25 KW PV, Classic 150,WB, Beta Barcelona, Beta KID
Sys 2: SW+ 5548s, 4KS25s, 5.88 KW PV, 2 ea. Classic 150, WB, HB CC-needs remote Monitoring/Control, site=remote.
 MN Bkrs/Bxs/Combiners. Thanks MN for Great Products/Svc/Support&This Forum!!

Westbranch

Yes, and tha alternative which  is a bit less cumbersome is to use the Local App from www.MidNitesolar,com /software   http://www.midnitesolar.com/firmware.php?firmwareProduct_ID=2
KID FW1811 560W >C&D 24V 900Ah AGM
CL150 29032 FW V.2126-NW2097-GP2133 175A E-Panel WBjr, 3Px4s 140W > 24V 900Ah AGM,
2 Cisco WRT54GL i/c DD-WRT Rtr, NetGr DS104Hub
Cotek ST1500 Inv  want a 24V  ROSIE Inverter
OmniCharge3024  Eu1/2/3000iGens
West Chilcotin 1680+W to come