Author Topic: MNBCB-BUSBAR mounting options?  (Read 106 times)

David

  • Jr. Member
  • **
  • Posts: 64
MNBCB-BUSBAR mounting options?
« on: September 11, 2018, 10:52:19 AM »
The MNBCB-BUSBAR only comes with insulators with metal threads embedded in bottom which means it has to be screwed in from behind the panel you are mounting it to.  How do I mount this to an existing power panel?  I was attempting to add this to my old Outback power system but ran into this issue.  Not sure if I can drill out the hole to use my own screws that would allow me to screw it in from the top?
« Last Edit: September 11, 2018, 11:16:56 AM by David »

David

  • Jr. Member
  • **
  • Posts: 64
Re: MNBCB-BUSBAR mounting options?
« Reply #1 on: September 11, 2018, 01:14:19 PM »
Looks like you can't drill hole through insulators.  Only way to make it work appears you have to mount the entire thing to a metal plate and then fasten the metal plate to whatever you want it mounted to.

ClassicCrazy

  • Hero Member
  • *****
  • Posts: 1901
Re: MNBCB-BUSBAR mounting options?
« Reply #2 on: September 11, 2018, 02:19:09 PM »
That sounds like a halfway easy solution

Larry
system one
Classic 150 , 5s4p  Kyocera 135watt , 12s Soneil 2v 540amp lead crystal for 24v pack , Outback 3524 inverter
system two
Classic 150 ,5s 135 watt Kyocero , 16s Calb 100AH LiFePO4 , Outback VFX 3648 inverter
system three
Midnite KID MPPT 24 DC in to  12 volt AGM batterie