Author Topic: SPD on Mobile Application w/ Victron Multiplus et  (Read 139 times)

desert_sasquatch

  • Newby
  • *
  • Posts: 1
SPD on Mobile Application w/ Victron Multiplus et
« on: October 02, 2020, 04:27:27 PM »
Hi Yall, thanks for hosting this forum!

So I've got a question:

I'd like to include surge protection (SPD 300 for the AC circuit) for my cargo trailer conversion.  The system will be 200 AH at 24 V, but the victron Multiplus will allow me to plug into shore power or a generator when necessary.  And like other high-end inverter/chargers, it includes automatic ground switching, meaning--I think--that when shore power is plugged in then "ground" is the AC ground wire but when shore power is not plugged in then the Victron is grounded (or "bonded," if you prefer) to the chassis through the negative buss bar. 

Anyhow, so I want to put a surge protector in there between the shore power and the rest of my stuff.

I'm confused about how exactly to install the Midnite SPD on a system like this.  According to the manual, one wire goes to "AC in", one to "AC out" and one to ground.  So far so good.

But in my system there are a set of wires (labeled Line, Neutral, and Ground) that all go to the "AC in" portion of the inverter/charger, and then there are another set of wires (Line, Neutral and Ground again) that make up the "AC out" portion.  And it seems to me like "AC in/out" mean different things in different contexts here, because I really don't know why we would want to measure the difference in voltage between shore power and the inverter output. 

To further complicate things, my rig won't be grounded to the actual earth unless it's plugged into shore power.  Much of the time the grounding will just be "bonding" to the chassis.  And I have no idea what this means for the placement of the neutral wire.  Does it still go to my negative buss bar, which is bonded to the chassis?  Or does it go to the ground "AC in" lug on the Victron? 

In summary, I really just want to know:  Where do I attach the SPD 300 so that it protects the system against surges originating from a connection to shore power?

Thanks so much!

ClassicCrazy

  • Hero Member
  • *****
  • Posts: 2670
Re: SPD on Mobile Application w/ Victron Multiplus et
« Reply #1 on: October 04, 2020, 06:38:55 PM »
Maybe this post will  help ?

http://midniteftp.com/forum/index.php?topic=2141.0

Larry
system one
Classic 150 , 5s4p  Kyocera 135watt , 12s Soneil 2v 540amp lead crystal for 24v pack , Outback 3524 inverter
system two
Classic 150 ,5s 135 watt Kyocero , 16s Calb 100AH LiFePO4 , Outback VFX 3648 inverter
system three
Midnite KID MPPT 24 DC in to  12 volt AGM batterie