Hello
I did a firmware, 1341 and 1122, update on my Classic 200 and my Classic lite 200, they are operating as follow me. I did a VMM on each by switching the MNGP back and forth. Now I can't find the lite on the MNGP.
Previously #10 was solar and # 12 was wind. Now #10 is wind and I can't find the lite with the solar. I've looked from #1 to about #35, I also went back further and saw "ALL" and some really high #'s 255 or something.
The lite is working and I can view and modify it from the local app. Can I somehow find it and maybe modify it's name and # to like 10 for one and 11 for the other?
Just curious why not use #1 and 2?
Thanks
Wade
the VMM resets the Classic to address 10. Plug the MNGP into the Lite and hold the left arrow and tap the up arrow to get to unused address 11. Now press and hold the left and right arrow at the same time until is says address is 11.
Now from the standard Classic you can scroll between the Classic and the Lite
Ryan
Quote from: Halfcrazy on March 26, 2013, 09:39:16 AM
Now from the standard Classic you can scroll between the Classic and the Lite
Ryan
Ryan;
I always wondered if you can view other Classics on the phone follow me net that have MNGP in them or does that only apply to lites. Be handy for widely separated Classics.
Thanks.
Tom
Yes this can be done. You can cable it with phone cables but not enable Follow_ME the Addressing of Classics is a separate function.
Ryan
Thanks Ryan
So any time I need to do some re-naming all I do is a VMM and start from scratch 8).
Thanks again
Wade
Um? No you should never need to do a VMM unless there is a major firmware release. To Re Name the Classic simply change its name in the local App
Ryan
Sorry Ryan
I guess I should have said re-numbering. Before the firmware update I had the same controller listed as #10 and #11 and couldn't figure out how to get it back to being only one #.
Thanks
Wade