Wizzbang unior WBJr

[cybermaus]

Hi

I see there is a new product, WBJr, that allows a Classic to read an extenally negative side mounted 50mA shunt.
My installation has such a shunt.

I try to figure out what exactly the Classic has for functions with this addon.

I read something about Amp-hours measured, positive and negative. I am guessing it allows for a better battery state monitoring based on total outgoing and incoming amps. I am sort of hoping there is also a parameter you can program with the banks capacity in AmpHour, so it can even show a percentage. Or (the bees knees) it can control low-bat or load-divert on Aux1 based on this percentage.

Thanks for any info.

Maurits

[DevoDave]

http://www.midnitesolar.com/pdfs/Whizbang_Jr_-_Install-1.pdf

Here is a link to the instructions.

Firmware (program) for the wonderful MidNite is always evolving.  Possibly what you are suggesting is in the future, or even under development now.

[boB]

No SOC (State Of Charge) yet.

That is still in the works.

boB

[cybermaus]

State of Charge is indeed what I want. Specifically controlling AUX1 with the SOC thresholds.

I'll not buy it yet and wait a bit then 

Thanks

[boB]

State of Charge is indeed what I want. Specifically controlling AUX1 with the SOC thresholds.

I'll not buy it yet and wait a bit then 

Thanks

So, what you want is an adjustable SOC threshold that when exceeded, brings the Aux 1 output high ?

boB