after using the new beta firmware i no longer can use the arc fault.was working fine at setting 12.went to 15 but any load on the inverter now makes it sound off. it was all good before the new firmware. any ideas.
What is the serial number of your classic ?
i.e. How old is it ?
hi bob
classic 150 3 mouths old all up to date
Quote from: NUMNUM on April 04, 2013, 08:44:53 PM
hi bob
classic 150 3 mouths old all up to date
ha ha, i like that one. is that older than 2 ears and a nose? :)
still looking for some ideas about the arcfault ,if someone could help serial # 05369
thanks
So the issue is it false trips no matter what now unless you defeat it? And it worked before? You did reboot the controller after making changes correct?
If yes to all 3 I am at a loss and would say we will need to RMA the Classic and get her back to check out. I am not aware of this being any bug in the code so it would appear it applies directly to this Classic.
Ryan
Ryan arcfault started working after installing beta 1370.but now the green led dose not come on when 150 goes to float.
Quote from: NUMNUM on April 11, 2013, 09:38:40 PM
Ryan arcfault started working after installing beta 1370.but now the green led dose not come on when 150 goes to float.
Is LED MODE set to Mode 1 ? Also, when you power up the Classic and the LEDs flash for a few seconds, does the
green LED on the remote (MNGP) flash too ? If the LED flash test on power up lights up, then it is probably that
the LED MODE is in Rick Mode or Off or something like that.
boB
If you did the VMM or Factory Restore LED mode will get set to Rick mode and the green LED will not display. Go into the Main menu, Scroll to Misc and hit Enter. Now look for LED-Mode and hit enter. Set this for LED1 and hit Enter.
Ryan