I am testing using Aux 1 for a diversion load. I have three classic 150 that are networked together with follow me turn on on two of them. One is set as the master and the other to follow. The third classic has follow me turned off. I have my Absorb voltage limit set at 28.8 and Float voltage limit set at 26.4. When I set the upper limit for waste not high at -.1 on one classic 150 and -.2 on the second. The low voltage point is set to -1. I expected to see the Aux 1 output switch at 28.7 and 28.6 but they switch at 28.3 and 28.4 when in absorb. I do not have a diversion load connected I am just testing the switching point. What am I missing on this. All of the classic 150 have 1933 firmware.
Edited: I forgot to say it was in absorb. I haven't had a chance to check the switching points in float.