Text only | Text with Images

A Forum run by Enthusiasts of MidNite Solar

Charge Controllers and Clippers => The "Classic" charge controller => Topic started by: solarfingers on September 16, 2015, 10:47:34 AM

Title: Wind Curve Programming Question
Post by: solarfingers on September 16, 2015, 10:47:34 AM
I have a 48v turbine ... does the cut-in voltage for the wind turbine have to match at 48v or can it be lower?  How much lower?

Thank you...
Title: Re: Wind Curve Programming Question
Post by: boB on September 17, 2015, 02:34:14 AM
The cut-in voltage for any turbine must be at least, higher than the battery voltage.

Different turbines will have different cut-in voltages.  It just depends on the turbine and how its
coils or stator is wound.

boB
Text only | Text with Images