I've been running classic CCs in hot weather and have noticed sometimes under lower loads the FETs won't get hot enough to trip the cooling fan cycles and this allows the PCBs to get a lot hotter - near 53C. I've even balanced out the limits in order to run a bit more current through a hot controller to warm up the FETs and trip the cooling cycle & cool down the PCB as well in the process. I don't mind doing some testing but I also wonder if there are adjustments to cooling parameters or can the fans be turned on remotely? Maybe a +47C FET is a bigger issue than a +52C PCB? Input from Classic expert appreciated as always.