Print Page - Possible use of classic150's Aux relay

Title: Possible use of classic150's Aux relay
Post by: Bryan on November 15, 2011, 05:54:05 PM

Is there any way to configure the classics Aux relay output to become active when the battery bank registers fully charged or is currently in a float mode??

I am trying to design a system that would prevent me from allowing a daily heavy inverter load to occur, unless the batteries were fully charged.

Title: Re: Possible use of classic150's Aux relay
Post by: Halfcrazy on November 15, 2011, 06:08:30 PM

The Classic does have a mode for Aux 1 that will make it active or non active (Your choice) when the Classic goes to float.

Title: Re: Possible use of classic150's Aux relay
Post by: Bryan on November 16, 2011, 11:50:04 AM

Thanks. This looks promising.

Bryan

A Forum run by Enthusiasts of MidNite Solar

Charge Controllers and Clippers => The "Classic" charge controller => Topic started by: Bryan on November 15, 2011, 05:54:05 PM