I have three Classics, all working just fine (no surprise there!)
On one of the three, however, the following happens when I push the "enter" button:
*loud beep
*screen goes blank (i.e. all pixels off)
*red led comes on (on MNGP)
*screen goes black (i.e. all pixels on)
*red led off + Midnite name and logo on MNGP
*MNGP info screen (firmware, serial, etc.) + red led on-off-on
This all takes around 5 seconds.
Thoughts?
Thanks!
Try to check to see if maybe one of the buttons are "stuck" on ?
boB
What version of the firmware are you on ?
Did you try a VMM reset to see if that fixes the issue ?
Larry
Did a hard reset, set my parameters back to my normal, symptom has now changed.
When I hit enter I get a continuous hifreq-lowfreq-hifreq-lowfreq audio that doesn't stop until I hit the "menu" button.
I can then hit "status" and get a status screen, but when I hit "enter" the whole sequence starts over.
Quote from: openplanet on November 03, 2021, 05:03:30 PM
Did a hard reset, set my parameters back to my normal, symptom has now changed.
When I hit enter I get a continuous hifreq-lowfreq-hifreq-lowfreq audio that doesn't stop until I hit the "menu" button.
I can then hit "status" and get a status screen, but when I hit "enter" the whole sequence starts over.
Well ! That annoying siren sound verifies that you most likely have the latest firmware !
We are working on testing the software that fixes that and some other things as well.
That ugly sounds was not supposed to be there ! Sorry.
boB
Quote from: boB on November 04, 2021, 02:02:21 PM
Quote from: openplanet on November 03, 2021, 05:03:30 PM
Did a hard reset, set my parameters back to my normal, symptom has now changed.
When I hit enter I get a continuous hifreq-lowfreq-hifreq-lowfreq audio that doesn't stop until I hit the "menu" button.
I can then hit "status" and get a status screen, but when I hit "enter" the whole sequence starts over.
Well ! That annoying siren sound verifies that you most likely have the latest firmware !
We are working on testing the software that fixes that and some other things as well.
That ugly sounds was not supposed to be there ! Sorry.
boB
Bob I think that beta firmware you posted a year or two ago fixed that siren noise.
I am using
MNGP 2197
Classic 2245
Larry
Quote from: ClassicCrazy on November 04, 2021, 04:02:32 PM
Quote from: boB on November 04, 2021, 02:02:21 PM
Quote from: openplanet on November 03, 2021, 05:03:30 PM
Did a hard reset, set my parameters back to my normal, symptom has now changed.
When I hit enter I get a continuous hifreq-lowfreq-hifreq-lowfreq audio that doesn't stop until I hit the "menu" button.
I can then hit "status" and get a status screen, but when I hit "enter" the whole sequence starts over.
Well ! That annoying siren sound verifies that you most likely have the latest firmware !
We are working on testing the software that fixes that and some other things as well.
That ugly sounds was not supposed to be there ! Sorry.
boB
Bob I think that beta firmware you posted a year or two ago fixed that siren noise.
I am using
MNGP 2197
Classic 2245
Larry
Thank you Larry ! I thought I did that but I think that software did NOT make it into production !
That needs to happen ! BUT now, there are a couple other changes we need to add to the MNGP remote so I think that may wait just a teeny bit.
boB