I just got my Classic 150 solar power system up and running. Im using the wizbang jr on specified 500 amp shunt. its working fine. I set all parameters that I know of per the included installation sheet. But night is falling so Im losing my solar input, and I think I am supposed to have the discharge limit set on my 600ah lifepo4 battery bank set so that the wizbang cuts off the inverter and its load at 20% capacity. But I dont see how you set this parameter. HOw to do this?
Hi Jim
There is an Aux 1 setting to have its output go high or low based on a State Of Charge percentage. (SOC%) You might want to look at that.
If your inverter can turn off and on by way of either a small relay or 12V to 15V signal, then that might work as well.
What kind of inverter is it you have ?
Others here may be more familiar with this nowadays but that is the first thing I could think of that might help.
boB