Beta Release 21_23.01.03.00 Fixes 2 bugs related to a factory restore
1- If you selected Flooded Batteries the unit would not charge as it did not have a Absorb voltage in its memory. A power cycle fixed this or adjusting Absorb fixed this.
2- If you selected anything other than Flooded Batteries the unit would limit to 1.2 amps until it was power cycled.
We released Beta code today 23.01.05.00 it fixed the bug where Arc Fault and Ground Fault would revert to Disabled after a power cycle, The unit now powers back up in the state it was on power down for these two items
We released Beta code today 23.01.09.02 it has a few minor bug fixes, it also tightens up the regulation a little
We released Beta code today 23.01.20.00
1- Added more Auxillary functions
2- Stabilized regulation at target voltage
3- Added more function to daily logging
Other enhancements for stability
Released 23.03.21.00
Fixed regulation to tighten tolerances
Fixed bug causing Absorb time to reset
Other functional tweaks behind the scenes
Released 23.11.10.00 today
1- Adds Remote Battery sense action, Will regulate on RBS but needs t0 get RBS from Rosie, Reading RBS coming soon
2- Improvements to tracking to reduce sweep depth and time etc
Released 23.12.19.01 today
1- drastic fixes to tracking, No more slow tracking and now it sweeps only as needed etc.
2- Added Remote Battery sense in completion
Released 24.01.17.01 Hbay and BCLNA code
Added some averaging to the logged High and Low battery voltage shown per day
Added Aux functionality (Still testing all of them)
Released 24.02.14.07 Hbay and Bclna code
1- Major fixes to tracking
2- Major fixes to regulation
3- Other tweaks for remote battery sense etc
It has been a while since I updated this or the firmware, Darren has worked on MPPT code a lot lately and we released 25.10.17.00 best served with newer MNGP2 code of 25.10.12.00 or newer
1- Revamped MPPT tracking all around for improved tracking
2- Added ramp rates based on SOC or Voltage to slow the tracking when close to full on Lithium to prevent over shoot
3- Fixed SOC when received from the canbus
4- Fixed a few other quirks behind the curtains
released 25.11.25.00
1- Lots of chanegs to tracking to improve low light
2- Changes to the sweep algorithm for closed loop to help with over shoot on batteries that dont PWM current when full
Released 26.01.14.00 today
Fixes All Aux functions
Fixes SOC reset to 100% on force float
Requires a device restore to fix Aux menus
I moved 26.05.08.00 to beta but I do not recommend updating unless you talk to support@midnitesolar.com first as this is a test firmware for a specific bug and as such is not highly vetted out