Print Page - Classic AUX Clipper control pwm output

Title: Classic AUX Clipper control pwm output
Post by: dgd on July 13, 2012, 06:09:53 AM

The classic 150 manual refers to an AUX output PWM Clipper that is a control for an attached Clipper. No specs are given for this. Can I use this
AUX output to drive a Crydom D53TP50D ssr? I have a micro wind turbine, MW General, that can output about 450W in a decent wind gust so I was thinking of using the ssr to switch in a 300W 2ohm resistor into each of the three phase outputs from the turbine.
Any advise appreciated.

Title: Re: Classic AUX Clipper control pwm output
Post by: Halfcrazy on July 13, 2012, 10:06:54 AM

Yes that is doable. As long as the ssr draws less than 200ma.

Here is a wiring diagram: https://dl.dropbox.com/u/31975941/clipper%20teledyne.pdf

A Forum run by Enthusiasts of MidNite Solar

Charge Controllers and Clippers => The "Classic" charge controller => Topic started by: dgd on July 13, 2012, 06:09:53 AM