Print Page - Top of pole mount ez-mount.

Title: Top of pole mount ez-mount.
Post by: guerrillasolarguy on September 12, 2012, 05:02:45 PM

Hello all,
I am new to this forum, and as an installer of renewable energy, I LOVE MidNite's product line.
I would like to see a simple kit for a pv combiner box that would make it simple to attach it to a pole. I have imagined a piece of aluminum "C" channel (shaped like 'track' that is used in metal stud framing 1"x4"x1" in the shape of a C) that is as tall as a combiner box with 4 slots cut into the tabs (2 on each tab, near the ends) to feed 2 large hose clamps that would go around the pole. Has anyone seen anything like this?
Joel

Title: Re: Top of pole mount ez-mount.
Post by: Halfcrazy on September 12, 2012, 10:45:56 PM

I will discuss this with the engineer tomorrow.

Ryan

Title: Re: Top of pole mount ez-mount.
Post by: vtmaps on September 14, 2012, 06:07:41 AM

Try a google search on "pole mount". There are plenty of options out there. I'm sure that if Midnite produces one it will be more elegant, practical, and affordable than the others.

--vtMaps

Title: Re: Top of pole mount ez-mount.
Post by: Robin on September 18, 2012, 09:53:26 AM

People usually just drill through the middle embosses in the chassis and bolt it directly to the pole. No additional mounting hardware required.

A Forum run by Enthusiasts of MidNite Solar

General Category => New Product Ideas and Discussion => Topic started by: guerrillasolarguy on September 12, 2012, 05:02:45 PM