Print Page - Pre-wired Midnite E-Panel for Magnum Energy inverter "bundle"

Title: Pre-wired Midnite E-Panel for Magnum Energy inverter "bundle"
Post by: clivusmul on September 28, 2012, 11:49:21 AM

Several Internet retailers advertise pre-wired Midnite E-Panels for Magnum Energy's 4448PAE Inverters. Part of this bundle is a included Magnum battery monitor ME-BMK. All the wiring diagrams, descriptions and installation instructions fail to show this ME-BMK installed anywhere in the E-Panel box. Question: Where is normal or designed place for this ME-BMK component in a pre-wired Midnite E-Panel? Does it fit inside the panel or is it installed external to the panel and wired through knock-out holes? Thanks.. bj

Title: Re: Pre-wired Midnite E-Panel for Magnum Energy inverter "bundle"
Post by: boB on September 28, 2012, 02:34:11 PM

The BMK sits next to the 500 amp 50 mV shunt.

I will highly suggest adding the BMK to the schematic.

Thanks !!

boB

A Forum run by Enthusiasts of MidNite Solar

Disconnect Boxes and Breakers => E Panel's, Disconnect Boxes and Breakers => Topic started by: clivusmul on September 28, 2012, 11:49:21 AM