I have setup one of the systems in my Garage / Freezer room / Woodworking ,mill work buildings. With all these machines & a built in Cyclone (dust extraction system) I still get a haze of very fine wood dust on the freezers fridges all over . I do a leaf blowing of the entire shop to keep the floors & wall hangings of tools with less dust.
I have tried the best way to combat the dust , but after a week or so of planning / sanding / cutting , you leave the shop & can still sneeze a 2x4 ..
I know that the Classics will start sucking in this dust , I have been dreaming of a forced air filtered air supply for just this reason.
My question is Gents / Folks , this been done ? and are the classics wet coast (PNW moisture ) tolerant ?
Im not going to dry the air , just filter it & have a positive pressure supplied to the base of the units to keep them cleaner.
Putting a enclosure on the outside / over them I can't see(they need cooling) , due to my dog who hates noise , gets sawdust eye goobies , and she is always FAR away .
So the question is , Have you see filters / a system for this filtered cooling air that Im deraming about ?
Thanks VT
The Classic has the capability to run in a sealed configuration (no fans, no vents) with power derating based on temperature.
You need a non-included kit, but if you contact MidNite, they should be able to help you out.