How do I navigate to put in the total Amp Hours of my Batteries on a 150 Classic. I did it when it was new along with the 2X360 AH LiFePo batteries but for the life of me can not find it again in any menu. & am experiencing reading anomolies eg; The 150 typically says 90% & the BMS on the LiFePo Batteries says 70% . These percentages are examples only. I just need the sequence in the menu to find " Battery capacity"
Hi Rafe, Welcome to the Forum.
You probably have this doc on installing and setup of the WbJr:
http://www.midnitesolar.com/pdfs/Whizbang_manual.pdf
Page 3 begins the Setup process.
Basically, press the left small Status screen button THREE times ... this gets you to the Wb Status screen. Press the upper Left soft button (More), which should allow you to set the AH Capacity value for your batteries.
Others here can tell you their settings for their LiFePo batteries.
Vic
Yes, and tha alternative which is a bit less cumbersome is to use the Local App from www.MidNitesolar,com /software http://www.midnitesolar.com/firmware.php?firmwareProduct_ID=2