Text only | Text with Images

A Forum run by Enthusiasts of MidNite Solar

Charge Controllers and Clippers => Midnite DIY Series => Topic started by: littleharbor2 on September 29, 2022, 07:13:13 PM

Title: Pulling fault codes on an MN3024 DIY
Post by: littleharbor2 on September 29, 2022, 07:13:13 PM
Maybe I haven't dug deep enough but I can't figure out where to get the fault codes to display. Anybody know off hand?
Thanks
Title: Re: Pulling fault codes on an MN3024 DIY
Post by: FNG on September 30, 2022, 01:43:09 PM
It will be in a box right in the top middle of the screen while active
Title: Re: Pulling fault codes on an MN3024 DIY
Post by: littleharbor2 on October 02, 2022, 12:13:55 PM
OK, thanks. I, being in my 60's need to carry my cheaters with me when I check out this stuff. I noticed the details on the screen are pretty small.
Text only | Text with Images