Text only | Text with Images

A Forum run by Enthusiasts of MidNite Solar

Charge Controllers and Clippers => Barcelona => Topic started by: Highflyer on January 21, 2024, 04:18:47 PM

Title: Input Two Not Enabled
Post by: Highflyer on January 21, 2024, 04:18:47 PM
After installing the latest software, I got a message saying MPPT 2 Mode "Not Enabled".  Any thoughts? 


Not enabled.jpg
Title: Re: Input Two Not Enabled
Post by: FNG on January 22, 2024, 08:14:53 AM
I have passed this info along to Mario, I dont think anyone else has seen this so I personally would do a system restore and set the system all up again, This was a major update and it changed a LOT of registers. If that doesnt work let me know
Title: Re: Input Two Not Enabled
Post by: Wizbandit on January 23, 2024, 07:31:10 AM
Works here. A bug flipping PV IN voltage display to 0 every seconds is all I see.   Previous and factory FW reading 0.0.0 he also knows about. Fixes on the way.
Title: Re: Input Two Not Enabled
Post by: Highflyer on January 23, 2024, 10:42:31 AM
Thanks for the updates.  Input one works as does HB, so my two larger arrays are covered.  Still would not trade them for any others, they are beasts.
Title: Re: Input Two Not Enabled
Post by: Highflyer on February 20, 2024, 07:48:02 PM
Well after some back and forth trouble shooting, it was determined my old beta boxes had old firmware on their MNGP2s. Midnite sent new ones and I am back in business.  The good news is I was able to take that time to figure out my new setup.  Time to get busy!
Text only | Text with Images