To visit MidNite Solar click this link www.midnitesolar.com
Quote from: aaapilot on April 23, 2024, 10:18:03 PMIt was tough to get the whizbang out of the minidc box i had it in. That is because I couldn't get to the shunt mounting screw without taking off the existing whizbang first - which was a pain to do in the back of the box. That is why I installed the spacers on the whizbang going back in - which is showed in the video ( link jumps to video at that time )Quote from: ClassicCrazy on April 23, 2024, 01:58:56 PMI stacked two Whizbangs - see in video how I did it .Thanks Larry, think I'll give this a try. There isn't much room in the Rosie chassis to get to the shunt, so I hope I can make it work. I'll take a look at your video!
Had to use spacers so I could get access to the shunt mounting screw .
https://youtu.be/7t7lw8ryIxA?si=5CuEpeRcCFfbBBxx&t=358
Larry
Dave
Quote from: boB on April 23, 2024, 07:09:23 PMYeah, long purple wire shouldn't be a problem. I don't know if one mile of wire would work but there is plenty of voltage from the Classic to power it and the data rate is so slow that it should work fine up to who knows how long of a wire...Thanks boB, I'll do that mod first chance I get. The distances are minor as the Rosie/Hawks Bay are just 12" apart on the wall. The Classic is next to the Hawks Bay on the opposite side.
Lettuce know if it doesn't work for how long you want it but if it is in the same room as the other equipment, it should definitely work.
boB
Quote from: ClassicCrazy on April 23, 2024, 01:58:56 PMI stacked two Whizbangs - see in video how I did it .Thanks Larry, think I'll give this a try. There isn't much room in the Rosie chassis to get to the shunt, so I hope I can make it work. I'll take a look at your video!
Had to use spacers so I could get access to the shunt mounting screw .
https://youtu.be/7t7lw8ryIxA?si=5CuEpeRcCFfbBBxx&t=358
Larry
Quote from: Off Grid Salt Spring on April 23, 2024, 01:56:40 PMI don't see much in the way of documentation on the MNGP2 yet. What about online interfacing/remote system monitoring? Is this currently functional in a new MNGP2/Rosie installation?