MN 3024diy issue

[littleharbor2]

Hope everyone's having a good sunday. So here's my situation my friends 3024 DIY went into low voltage fault number four i'm reading that it should reset after the voltage gets back to 27 volts but that's not happening. Trying to figure out if there's a way around this. They have no power at the moment

[Wizbandit]

Be sure parm-1 is set to UTI and parm-35 set low enough.

[littleharbor2]

Be sure parm-1 is set to UTI and parm-35 set low enough.

Thank you, I will check those out.