where did my display go ??

[BlackwaterPark]

Well try to get that done tomorrow... I've earned a day off to town anyway,  heh.  In any event,  even if the ah reading is incorrect,  well the SoC% still be accurate?

[Westbranch]

I don't think so as it will be based on the bigger AH,
but your amps in and out of the battery will be right, if you can get that info...

Did you press enter after you reset the battery Ah?  If not the new value is not saved.

In my problem crash, I came back after 2 winter months and the Classic showed  a 12V battery  BUT it is 24V..  LApp solved the problem

[BlackwaterPark]

What's laPP?  I just noticed i can change the actual ah value manually, but I'm to understand that new batteries take some cycling to get up to thier full potential, so I'm thinking that just changing it to 225 may still be inaccurate.   The voltage readings are all correct for a 24v system though.  Where is the menu to see what the nominal voltage setting is set to?

[Westbranch]

LApp is the Local App.  It makes looking at the settings and changing them a lots faster as there is no need to press all those buttons on the MNGP (MidNite Graphics Panel)...

go here http://www.midnitesolar.com/

and it is right under Webinar, center of the page

[BlackwaterPark]

Ah, thanks for clearing that up. If the local app is based off a wifi, i can't use it anyway, though i do have the app on my phone.   A bluetooth function sure would be nice though   i got a lot to read up on over the next couple days.

[Westbranch]

you can hardwire it , or use a wifi bridge to a modem, etc...
don't know if a Bluetooth from the phone to a bridge works.. 
there are also some videos mentioned on the MN home page that will help...