Raspberry Pi Classic monitor using MQTT

Started by ClassicCrazy, March 23, 2020, 04:08:28 PM

Previous topic - Next topic

ClassicCrazy

Take a look at this - was a bit different question about SMA but I think the same principle applies to your situation.
http://midniteftp.com/forum/index.php?topic=5000.msg46537#msg46537

Larry
system 1
Classic 150 , 5s3p  Kyocera 135watt , 12s Soneil 2v 540amp lead crystal for 24v pack , Outback 3524 inverter
system 2
 5s 135w Kyocero , 3s3p 270w Kyocera  to Classic 150 ,   8s Kyocera 225w to Hawkes Bay Jakiper 48v 15kwh LiFePO4 , Outback VFX 3648 inverter
system 3
KID / Brat portable

ClassicCrazy


FNG

    Administrator
    Sr. Member
    *****
    Posts: 277
        View Profile Email Personal Message (Offline)

Re: One Classic 250 MNGP's mirrors the other Classic 250
« Reply #34 on: October 01, 2020, 11:44:59 AM »

    Quote

Ok the issue with addressing the classics using the local app is it does not address the MNGP. You dont want to use the local app for addressing on classics only classic lites.


and this

Actually to address the classic is done from the home screen. On page 21 of this manual

http://www.midnitesolar.com/pdfs/Classic_ClassicSL_Manual_10-001-1_REV_L.pdf

To address a Classic simply use the MNGP that is plugged into that Classicor plug the MNGP into that Classic and hold the LEFT ARROW keydown and tap the UP or DOWN ARROW key. The normal default address is 10 so going up will take you to 11 and down to 9. When you get to the unused address you want for that Classic, hold the LEFT and RIGHT ARROW keys for a second until “Data Sent and Saved” shows up. Now this Classic has been re-addressed to the new address.
system 1
Classic 150 , 5s3p  Kyocera 135watt , 12s Soneil 2v 540amp lead crystal for 24v pack , Outback 3524 inverter
system 2
 5s 135w Kyocero , 3s3p 270w Kyocera  to Classic 150 ,   8s Kyocera 225w to Hawkes Bay Jakiper 48v 15kwh LiFePO4 , Outback VFX 3648 inverter
system 3
KID / Brat portable