Beta Firmware

[FNG]

Released 24.11.08.00
1- Added closed loop support for MNGP2
2- Added global current limit
3- Tweaks to generator charging
4- Added 3 phase functionality (3 Rosies all set to 120V for 120/208 3 Phase)

[FNG]

Released 24.12.16.00 today this fixed the bug where some Rosies would show Battery over temp and Battery under temp and prevent Rosie from charging

[FNG]

Released 21.25.01.28.07

1- Added the transfer to grid when overload occurs and the Rosie is in LBX or Time of use, Must enable Load XFER for this to work, Wattage setting doesnt matter for the overload transfer
2- Added a 5 minute timer to Grid support/sell mode (Sell is an unlisted function at this time but works great)
3- Adds 3 phase stacking with 3 Rosies
4- Enhancements for closed loop
5- Added Stack balancing

[FNG]

Released 25.02.13.00
Many fixes:
1- Added Little Rosie support
2- Fixed canbus register bug causing issues with global info
3- Added 5 minute connect timer for qualifying grid when in grid sell vs 10s when not (Remember sell is not a listed feature but it works)
4- Added load transfer when in time of use or lbx and L1 OR L2 overload it will now connect to grid
5- Fixed battery high and low temp error found on some Rosies
6- Added support for 3 phase 120/208
7- cleaned up a lot of stacking concerns in older firmware

[Kurt_the_German]

Released 24.05.21.00 today

1- Fixed AC coupling bug where Rosie would throttle at 1/2 the target power
2- Added 150 watt low limit to grid support to keep any unintentional short sell backs from happening
3- Added a dual ramp rate to ramp slower on generator inputs
4- Fixed bug in LBCO setting not allowing it to go to full range of settings

Don't know if I'm in the right thread here, but I assume the MNLR3648M (little Rosie) uses the same firmware.

My question, with the new firmware, what is the LBCO voltage range one could set the MNLR3648M to?

This would be useful to know if one wants to run the little Rosie with LiFePO4 batteries open loop.