Beta Firmware

[FNG]

Released 24.11.08.00
1- Added closed loop support for MNGP2
2- Added global current limit
3- Tweaks to generator charging
4- Added 3 phase functionality (3 Rosies all set to 120V for 120/208 3 Phase)

[FNG]

Released 24.12.16.00 today this fixed the bug where some Rosies would show Battery over temp and Battery under temp and prevent Rosie from charging

[FNG]

Released 21.25.01.28.07

1- Added the transfer to grid when overload occurs and the Rosie is in LBX or Time of use, Must enable Load XFER for this to work, Wattage setting doesnt matter for the overload transfer
2- Added a 5 minute timer to Grid support/sell mode (Sell is an unlisted function at this time but works great)
3- Adds 3 phase stacking with 3 Rosies
4- Enhancements for closed loop
5- Added Stack balancing

[FNG]

Released 25.02.13.00
Many fixes:
1- Added Little Rosie support
2- Fixed canbus register bug causing issues with global info
3- Added 5 minute connect timer for qualifying grid when in grid sell vs 10s when not (Remember sell is not a listed feature but it works)
4- Added load transfer when in time of use or lbx and L1 OR L2 overload it will now connect to grid
5- Fixed battery high and low temp error found on some Rosies
6- Added support for 3 phase 120/208
7- cleaned up a lot of stacking concerns in older firmware

[FNG]

Released 25.09.09.00
1- Fixes a quirk with logging that could on rare occasions cause the Rosie to reboot and thus shut power off for 1-5 seconds
2- Adds full support for closed loop
3- Increases the support for parallel Rosies for more than 2
4- General tweaks on operations

[FNG]

Released 25.10.27.00
1- Changed Grid support to allow the voltage to go down to 47 (Used to stop at 48)
2- Changed the charging behavior on Rosie when no MPPT present or MPPT unlinked Rosie will only start a new bulk charge when Rebulk is hit or the AC IN is lost for 1HR or more to prevent back up systems from fully charging every evening