To visit MidNite Solar click this link www.midnitesolar.com
Started by ClassicCrazy, February 12, 2024, 09:25:34 PM
Quote from: Muskoka on February 14, 2024, 06:09:46 AMHow does the low temp charge cutoff work for LiFePO4 with the new firmware, what temp is it based off of? Do I need to reconnect the Temp sensor to the battery so the battery temp is recorded, but leave it set to "Disabled" as far as temp compensation goes?
Quote from: Muskoka on February 17, 2024, 08:48:14 AMJust noticed, since re-installing the temp sensor on my battery to enable the LiFeP04 low temp charge cut off, the total battery capacity amount reported by "Classic Monitor" android app is incorrect, it's always been spot on. I have the battery size correctly set in the Classic, 280ah, Temp Comp is disabled.The android app is showing "Total Capacity" 256ah, "Remaining Capacity" 233ah, Net Charge -66ah. The current reported battery temp is 16.1c.I've also installed the Local Status App on my computer, under Config the only screen I have access to is "Settings". The other tabs, "Basic", "Advanced", and "Tech" are greyed out.Just did a test. Powered down the Classic, removed the temp sensor, fired it back up, and the android app shows the proper battery capacity again, as set in the Classic, 280ah. Shut down the Classic, reconnected the temp sensor, and the battery capacity shows 256ah again. Something doesn't seem right in the new firmware with the temp compensation?I'm leaving the temp sensor unplugged for now. More important to me to have an accurate count of what's left in the tank.