Energy Gauge Bottoms out @ 10 Kwh

Started by WizBandit, August 20, 2012, 08:25:52 AM

Previous topic - Next topic

WizBandit

Each of my 3 Classic's produce in excess of 10 Kwh per day. Can the ENERGY GAUGE be set to "auto expand" to a scale of say 20 after 10 Kwh is hit? I'm afraid of bending the needle keeping it pegged @ 10 Kwh all afternoon ;)

Halfcrazy

That is in the works. I think we plan to start at 5KWH and have it go in jumps of 5

Ryan

Changing the way wind turbines operate one smoke filled box at a time

WizBandit

Man, these Classic's are doing a great job. We had (still as of 9pm) rolling storms coming in off the gulf of Mexico all day. It would go from bright & sunny to overcast, pouring rain and then to sunny, repeat. The Classics quickly found the MPPT points and followed it during this whole madness. The total daily power produced was equal to if not greater than the old charge controllers I had installed during a bright cloudless day. Good Job Engineers.

boB

Quote from: WizBandit on August 20, 2012, 09:23:50 PM
Man, these Classic's are doing a great job. We had (still as of 9pm) rolling storms coming in off the gulf of Mexico all day. It would go from bright & sunny to overcast, pouring rain and then to sunny, repeat. The Classics quickly found the MPPT points and followed it during this whole madness. The total daily power produced was equal to if not greater than the old charge controllers I had installed during a bright cloudless day. Good Job Engineers.


Thank you, WizBandit !!   That is really appreciated !

Always thinking about how to make it better, too.   There is still just a slight bit of room for improvement, but not very much.

boB
K7IQ 🌛  He/She/Me