Force SOC reset.

[Mike W]

I upgraded my classic 150 to the Jan 8th code last night. This morning I noticed the classic wasn't talking to the WIzbang. After disconnecting and then reconnecting the purple wire to Aux 2, the WIzbang was back online. However the SOC is showing 37% which is way low (should be about 86%).
I've looked in the manuals but didn't see a way to manually reset the SOC to 100. Is there a way to do this or when the Classic goes to float this afternoon will it straighten out? It had been working great previously to the code upgrade.
Thanks,
Mike

3 Kyocera 245W panels, 2 Kyocera 135W panels, classic 150, 640AH lifeline AGM batteries on a boat

[Halfcrazy]

Mike
Yes letting it go to float once will recalibrate it to 100%.

[Mike W]

Thanks Ryan!

[boB]

You should also be able to reset it to 100% manually by going to the WB Jr. status menu, pressing the
soft-left key (MORE) and then (I think)  hold down the LEFT ARROW key  and hold down the ENTER
key for just a moment (second or less) and the flashing SOC% should stop flashing and be sitting
at 100% SOC.

boB

[Vic]

Thanks boB for that reset trick.  Knew that you had mentioned it here before,  but forgot just where it was.   Thanks,   Vic

[Mike W]

Thanks boB!