Classic AUX Clipper control pwm output

Started by dgd, July 13, 2012, 06:09:53 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

dgd

July 13, 2012, 06:09:53 AM
The classic 150 manual refers to an AUX output PWM Clipper that is a control for an attached Clipper.  No specs are given for this.  Can I use this
AUX output to drive a Crydom D53TP50D ssr? I have a micro wind turbine, MW General, that can output about 450W in a decent wind gust so I was thinking of using the ssr to switch in a 300W 2ohm resistor into each of the three phase outputs from the turbine.
Any advise appreciated.
Classic 250, 150,  20 140w, 6 250w PVs, 2Kw turbine, MN ac Clipper, Epanel/MNdc, Trace SW3024E (1997), Century 1050Ah 24V FLA (1999). Arduino power monitoring and web server.  Off grid since 4/2000
West Auckland, New Zealand

Halfcrazy

#1
July 13, 2012, 10:06:54 AM
Yes that is doable. As long as the ssr draws less than 200ma.

Here is a wiring diagram: https://dl.dropbox.com/u/31975941/clipper%20teledyne.pdf
Changing the way wind turbines operate one smoke filled box at a time
Print
Go Up Pages1
User actions