News:

To visit MidNite Solar click this link www.midnitesolar.com

Main Menu

Classic 150 Voice Setup

Started by labusker, December 10, 2020, 02:53:36 PM

Previous topic - Next topic

labusker

I tried to set up voice but had no success. Does it supposed to work?
My settings: Classic Rev: 2193
Volume: 65, Audio: ChattyCathy, Message Interval: 1 minute, Quiet Time: Off
Reboot: yes after setting

KyleM

Is the speaker in the MNGP hooked up?

ClassicCrazy

How old is your Classic ? If it is an older one you also have to upload voice files to MNGP in case you didn't do that .

Larry
system 1
Classic 150 , 5s3p  Kyocera 135watt , 12s Soneil 2v 540amp lead crystal 24v pack , Outback 3524 inverter
 5s 135w Kyocero , 3s3p 270w Kyocera   Classic 150 ,8s2p  Kyocera 225w to Hawkes Bay Jakiper 48v 20kwh  ,Gobel 16 kwh  lifepo4 Outback VFX 3648  8s2p 380w Rec pv EG4 6000XP

labusker

I have a blue cable plugged in to the top connector of the classic then to the MNGP so I assume the speaker is connected.
I bought the classic 150 in Feb of 2020 so I think it would have the latest software.

KyleM

Quote from: labusker on December 11, 2020, 10:26:54 AM
I have a blue cable plugged in to the top connector of the classic then to the MNGP so I assume the speaker is connected.
I bought the classic 150 in Feb of 2020 so I think it would have the latest software.

The speaker wire is inside the MNGP cover.
https://www.solar-electric.com/lib/wind-sun/classic-quickstart.pdf
In this quick start guide on page 10 is shows you a good picture of the wire in question.

-Kyle

labusker

KyleM, you did it. I found the disconnected wire, put it on, and now she works. I looked all over the regular manual for the speaker, but could find nothing. Why would this be left out the main manual? Now hopefully she does not talk too much. It's a feature I do not need but since its there I want it to work.