BatteryChargeStatus

[EnoughToBeDangerous]

I seem to have lost the percentage of battery charge on my display following a dc battery drain event. Is there a setting that I have to verify configuration of to get that back? I though I was seeing it prior to the event on one of the "main" display screens.

- Wizbang is showing data and AH  (in this case showing 227 AH remaining) and SOC shows 56%.

Any bone's you could throw on the subject would be much appreciated.

[ClassicCrazy]

Display on what ? MNGP screen ?
If the Classic was off it will take until the next time the batteries fill up again to Float before the SOC reads properly.
Larry

[boB]

IF you know that your battery is charged up to 100 % SOC, there is a button in one of the extra WB Jr. menus to force it to go to 100%.

The other way it forces to 100% SOC is to let the Classic run an Absorb cycle and go to Float stage which should reset it to 100%

You could temporarily change the Absorb time to a couple of minutes and force a BULK charge to get it to do that too.

But only if you think your batteries are fully charged.   Finding the actual battery capacity in Amp-Hours is a bit of a different story but can also be found if you charge the batteries up as full as you can and discharge a known number of Amp-Hours until the battery voltage or specific gravity indicates an equivalent discharge amount and calculate the newly found capacity accordingly.

Not hard to do but takes a bit of time so the battery isn't discharged too quickly.