newly installed Classic 250...

[alyaz]

I'm not able to locate 'wizard,' in the menu as per the guide instructions.  To clarify, the firmware updates have deleted the wizard? 
And the audio function is not yet operable?  My quick start manual states, 'Audio: Here you can select between the Modes of speech the Classic will use. (Not active yet).  Mine doesn't even beep, so wondering if the audio is not functioning, or if no audio (beeping or speech) is yet up and running?

[boB]

Hi alyaz...

Sorry, the audio has not been implemented yet.  The MNGP does beep but only when there is
an arc fault or GFP right now.

Funny thing is that the MNGP used to beep a long time ago before the Classic was released whenever
you pressed a key.  A different beep tone for each key too.  When we went to the much more
capable audio circuitry, there were more pressing issues and we couldn't get it implemented
at the time.  BUT, good timing for your question as work is just now starting on this !
All the hardware is there.  You will also need to plug in the speaker.

Also, no more Wizard for the time being.  It was very complicated and was easier for customer
to use the QuickSet (VMM or Vulcan Mind Meld) settings initialization.

We will be bringing back a few of the old wizard menus though like, latitude/longitude, Sunrise/Sunset,
and maybe wire sizing.

boB