Hawkes Bay Lithium settings / labels / Aux

[ClassicCrazy]

Can the Lithium charging labels be explained ?
Compared to the Classic the Hawkes Bay was in a state that said Balancing. How does it determine this ?
Then it went to Maintaining , now to Resting with zero output.
The battery voltage is at 54 and I have the Absorb setpoint at 55.2 and Float at 54.0 with 5 minute absorb time.
Are there going to be new menu setpoints in the future for the Balancing , Maintaining, etc ?
Even though the ending amps was set to 0 , it has reverted after some time to 65535. It won't let me change this on the MNGP2. It had been showing the 65535 in past firmware updates but cleared to zero on last 23.11.6 mngp2 and 23.11.10 Hawkes Bay updates.
I do have a Classic also charging on this system so maybe it is confusing the Hawkes Bay ? But the Classic has the same setpoints .

Unrelated to the charging is that there is no indicator on the MNGP2 to show when the Aux is active . I still have not figured out the Waste Not - on the latest firmware update there is now no longer the ability to change from PWM to non-PWM .  I can still  change the output from Manual On / Manual Off / and Auto

thanks - Larry

[boB]

I would stay away from Waste not until the end of the week where we can bring it up again.

The guys are testing on WN in particular I believe.

I'll give them a little nudge.

boB