Since firmware update "Resting" mid day....

Started by Muskoka, October 24, 2016, 04:13:08 PM

Previous topic - Next topic

Westbranch

I believe, from memory,  there is a setting dealing with low light startup , that should mean you would be ''Resting'' if not producing...  ??? 

It was a way of stopping an early summer clatter of the relays...
Do you have a value entered there?
KID FW1811 560W >C&D 24V 900Ah AGM
CL150 29032 FW V.2126-NW2097-GP2133 175A E-Panel WBjr, 3Px4s 140W > 24V 900Ah AGM,
2 Cisco WRT54GL i/c DD-WRT Rtr, NetGr DS104Hub
Cotek ST1500 Inv  want a 24V  ROSIE Inverter
OmniCharge3024  Eu1/2/3000iGens
West Chilcotin 1680+W to come

CDN-VT

Quote from: Muskoka on October 26, 2016, 02:41:14 PM
Everything is just fine. TS-60 went to float first, followed by the Tristar Mppt and shortly after the Classic Lite, after 3 hours of absorb. And, 30 seconds after the Classic Lite went to float my 400w heater kicked in as it should through the Fotek relay connected to Aux1, Float Hi mode. The heaters still running, with many starts of the fridge, all controllers are still in float, and continue to cover all the loads. Guess I'm all back to normal and good to go. All the battery cells are sg of 1.265 or slightly above, with no "spewing" from the Water Miser caps. Haven't seen "Resting" on the Classic Lite yet today. It's still chugging away providing 20a, and the TS-60 is pitching in with the other 15a that are necessary for current loads. Thanks again to everyone that helped :)

Glad it's back to what you had.
If you now have a MNGP installed into your lite , I would now  call it just a classic & stop the confusion some (Like me think or don't  ;) )

VT
Canadian Solar 350W 37.6 VOC  30.6 VMP 8.22 ISC 7.87 IMP ,-15 c +30c max  4 strings in 2 in Series for 24v Classic 150 -1020 Ah  Freezers & fridges ~~~ Second Array same panels of 3sx3 parallel for 24 V Classic 150 -440 Ah Outback Barns & out blds.
48Vdc almost done,11Strings up of 3s11P same panels