LR firmware

[Kurt_the_German]

Released 24.05.21.00 today

1- Fixed AC coupling bug where Rosie would throttle at 1/2 the target power
2- Added 150 watt low limit to grid support to keep any unintentional short sell backs from happening
3- Added a dual ramp rate to ramp slower on generator inputs
4- Fixed bug in LBCO setting not allowing it to go to full range of settings

Don't know if I'm in the right thread here, but I assume the MNLR3648M (little Rosie) uses the same firmware.

My question, with the new firmware, what is the LBCO voltage range one could set the MNLR3648M to?

This would be useful to know if one wants to run the little Rosie with LiFePO4 batteries open loop.